MustangWorks.com : Ford Forums

MustangWorks.com : Ford Forums (http://forums.mustangworks.com/index.php)
-   Windsor Power (http://forums.mustangworks.com/forumdisplay.php?f=8)
-   -   Where'd the lowend go? (http://forums.mustangworks.com/showthread.php?t=23176)

94GTConv 05-03-2002 03:45 AM

Where'd the lowend go?
 
Guys need a little help. Got a 94 GT and Lost a lot of my low end pressure and the car is running like crap. Check engine light came on and I'd rather not spend 80 bucks on a ScanTool.
I thought at first it would be a clogged cat or something, but since its true dual it can't. So what do you guys think it is? My next guess is O2 sensor that sound right?

sn95gt19 05-03-2002 10:19 AM

LOL, these cars are a pain in the *** when something goes wrong, cause its a pain to track anything down, could really be anything from-plugs and wires-tfi module-timing-fuel filter-bad mass air sensor-i really dont know how to help you, if you are popping up a check engine light, you can do the scan yourself with a couple of jumper wires.

94GTConv 05-03-2002 03:50 PM

Damn you have a badass GT.
Thanks for the jumper cable idea, but I don't have a clue as how to check it with them.

gtsr515 05-03-2002 03:56 PM

How do you know you lost low end?, Or ANY end?, is this a "Butt Dyno Assumption Test" or is it your car is just running bad RESULTING in your loss of low end power, no flames here bud, i'm just a little confused as to what you want here, glad to help any way we can!:)

94GTConv 05-03-2002 04:02 PM

It's just the low end power. The high end seems alright (it was never that great in the first place, but no noticeable change). Thanks for any thoughts.

95mustanggt 05-03-2002 04:22 PM

Find the data connector behind the passenger side front fender. Take the cover off. Take a jumper wire and do connect as follows:

http://members.mustangworks.com/95mu...mages/diag.jpg

Make sure the car is off. Connect the wire.

Get in the car and turn the car on (but don't start it).

Wait a few seconds. You should hear the fan rev up and then your check engine light will flash.

It will flash 2 sets of codes, one is the current problems, the other is problems in memory. The separator code is 1-1-1.

Either post your codes or buy a Haynes repair manual. It will give better instructions to connect, and give all the error codes.

Hope that helps.

94GTConv 05-04-2002 03:39 AM

Thanks. Really appreciate it. I'll give that a crack tomorrow see what I can come up with.

srv1 05-04-2002 08:40 AM

Imports are like tampons.... Every pussy has one.
OH!!! that would have to be the best one yet! haha

find out the code. i dont know how much you know about cars, so i will link you to a pagee that may help you if you need it.

codes

94GTConv 05-04-2002 10:34 PM

Thanks src. I have the codes though. Just not the time until tomorrow.
P.S. I love the buddy christ icon. I have a buddy christ on my dashboard.


All times are GMT -5. The time now is 01:50 PM.