White Face Gauge install tips
 

can some one give me some tips on installing white face gauges...like how to make sure you get the needles on where they were etc.

------------------
'91 GT,91K,T-5,air silencer removed,racing clutch(previous owner put in so dont know what kind),K&N air filter,Aiwa deck,power acoustic amp,2 12" pianeers,Mac long tubes,Cat-back,off road H,FMS 9mm wires

Future Mods:3.73's,Pro 5.0,Shifter knob,E303 cam,cobra intake,76mm MAF,70mm tb
ICQ#35670781

I put a set in my '94 a week ago- my tip: be careful not to drop the needles!! that sucks, trust me http://www.mustangworks.com/msgboard/frown.gif once i was done, i thought i had the needles on perfect, but when i hooked everything back up, they were all a little off, so i had to do some fine tuning.

take a photo or draw a picture of where your needles are while the car is running before you take the needles off. once you get the gauges switched, you'll need to calibrate the needles while the car is running again. that seems to be the best (if not the only) way to get them accurate. this may not work for your speedo, though. that you might need to do on the road with a friend in another car or something... hope that helped!

greg

Make sure you clean all of the glue off. I know it is clear and what could it hurt, but trust me make sure it's all off.

------------------
Check my site for mod
www.fordmustanggt.com

anyone else? so far i got "draw a picture"...

------------------
'91 GT,91K,T-5,air silencer removed,racing clutch(previous owner put in so dont know what kind),K&N air filter,Aiwa deck,power acoustic amp,2 12" pianeers,Mac long tubes,Cat-back,off road H,FMS 9mm wires

Future Mods:3.73's,Pro 5.0,Shifter knob,E303 cam,cobra intake,76mm MAF,70mm tb
ICQ#35670781