Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-27-2001, 03:58 AM
|
#1 |
|
Registered Member
Join Date: Aug 2001
Location: Ft. Worth, TX
Posts: 456
|
Who can help? Question about EGR spacer and heater...
What is the purpose of having the coolant lines hooked up to the EGR spacer? I was thinking about capping it off and running a straight line from the water pump to the heater core. I will use a braided line and put a flow restrictor in the heater inlet so the pressure won't screw it up. Then there will be a braided line from the heater core back to the water pump. I am using braided just for looks and durability. Hey, I have some laying around. This way I can remove the whole EGR/heater tube to clean up the engine compartment. Is there any problem with this setup? Has anyone tried it?
__________________
You're gonna need your seatbelt |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Egr Spacer | 289 | Windsor Power | 3 | 10-08-2002 03:41 PM |