650hp on the motor?
Not that I am doubting Bennett's ability,but 650hp from a hydraulic roller is asking a lot,especially in the rpm range you are looking for,the cam is not the problem but the lifters,and you have to be careful of them collapsing,if it was me looking to make that kind of power,I would run solid rollers,you will definitely make the power with a solid roller,and it does not have to be a wild cam either.
I would go with the Super Victor converted to fuel injection,I know the Eddy Victor is good to 5000-8000rpm,but it is still a fuel injected manifold.
No offense but why not run a carburetor? You will definitely make the power no doubt with a Super Victor,950HP carb,and some compression,somewhere is the 11.1 to 12.1 range,and then that nitrous shaker will really wake you up.
TFS R is a good intake but 650hp is a lot to ask a fuel injected manifold.
Good luck with your combo.
__________________
OC
"there are 5,000 Army troops sitting on their butts doing nothing,while 2 companies of Marines are securing this island" spoken by a Army General on the Isle of Grenada in 1983
|