MustangWorks.com : Ford Forums - View Single Post - Will a flywheel from an '85 work on a later 5.0?

red82gt · 07-30-2001, 05:26 PM

It can work, there will be 3 bolt holes that will line up with the 10 1/2" pressure plate. Take the pressure plate and flywheel to a machine shop and have them drill the remaining holes and have them fit it with dowel pins. I had this done with my stock 82 flywheel when I got a 10 1/2" clutch.

------------------
GT-40 heads (ported, polished, + milled), B303 cam, 1.7rr's, JE pistons, Offy intake, Carter AFB 625cfm carb, Flowtech 1 5/8" shortys, Flowtech X-pipe, MAC Flowpath exhaust, MAC pulleys, 373's, subframes, Eibachs+Tokicos, B&M ripper, FMS Clutch, Zoom Quadrant+cable, 17" CSA Ultra rims, 235/45ZR17 Yokohama AVS S4's, MSD 6A ignition+coil, FMS 9mm wires, Carbed, Naturally Aspirated, and Nasty!

07-30-2001, 05:26 PM	#2
red82gt Sober voice of Reason Join Date: Nov 1998 Location: Kelowna, B.C., Canada Posts: 1,514	It can work, there will be 3 bolt holes that will line up with the 10 1/2" pressure plate. Take the pressure plate and flywheel to a machine shop and have them drill the remaining holes and have them fit it with dowel pins. I had this done with my stock 82 flywheel when I got a 10 1/2" clutch. ------------------ GT-40 heads (ported, polished, + milled), B303 cam, 1.7rr's, JE pistons, Offy intake, Carter AFB 625cfm carb, Flowtech 1 5/8" shortys, Flowtech X-pipe, MAC Flowpath exhaust, MAC pulleys, 373's, subframes, Eibachs+Tokicos, B&M ripper, FMS Clutch, Zoom Quadrant+cable, 17" CSA Ultra rims, 235/45ZR17 Yokohama AVS S4's, MSD 6A ignition+coil, FMS 9mm wires, Carbed, Naturally Aspirated, and Nasty!