© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
05-04-1999, 05:22 PM | #1 |
Registered Member
Join Date: Feb 1999
Location: NC
Posts: 179
|
c-4
Hi all
I know after you read this post you will ask why, so it is to drive it to another state to register it. Can I bolt a C-4 tranny up to my 4banger mustang? Thanks ------------------ 91LX Awaiting 351W heart transplant |
05-05-1999, 02:08 PM | #2 |
Moderator
Join Date: Sep 1998
Location: Grand Rapids, Michigan, USA
Posts: 1,001
|
Depends. Does the converter & converter (bell) housing match up? I know for a fact the housing on my 3.3L is very unique, and you can't find 'em anywhere! You'll have to use a ruler and measure where the tranny bolts up, then if it does match, there shouldn't be a problem. Also, check the distance from the crossmember to the back of the engine. It should also be the same on the C4 you plan on bolting up. Good luck!
------------------ Capri306 1979 Mercury Capri I can roast 'em off the line & squawk 'em in second! 3.3L --- C4 w/ B&M Shift Improver Kit, rebuilt with TCI stuff --- 2.73 --The only paid mechanic in high school auto shop-- "Yes, officer, I only have 85 horsepower! I couldn't have been going 98!" |
05-17-1999, 03:56 PM | #3 |
Registered Member
Join Date: Feb 1999
Location: Columbus, OH USA
Posts: 226
|
i dont believe it will work, the 4 banger is so much smaller then the 302, the bellhousing on the c4 will be much bigger, and wont fit. The bolt pattern on the 4 banger is not the same either.
------------------ '93 notch converted to a 5.0 AOD, off road H-Pipe, 2 1/2 inch flows, 3.73's, 110 lph pump, K&N, Alum. driveshaft, B&M flexplate. No ET with the 5.0 yet. Columbus, Ohio |
|
|