My Good Experience With Ford Parts On Line - Good Discounts

Maroon 5.0 LX · 10-03-2001, 09:09 AM

My hard-headed local Ford dealer would only give me 10% off on parts, so I tried http://www.fordpartsonline.com Ford Parts Online. Their web site is still being built, and is very slow. Here are a couple of sample prices for Motorcraft parts, which are pretty much in line with after-market prices:

EGR - List: $127.33 My cost $74.49
O2 Sensor - List: $ 87.62 My cost $45.41

I ordered late on a Friday afternoon, and parts were shipped the following Tuesday. All done by e-mail, and they were pretty prompt replying. They do have an 800 number. Order was shipped UPS Ground, ($7.00) which took a week, unusually long for coast-to-coast shipment. May be due to aviation delays lately. (ground shipments do go on aircraft)

All in all, I'm pleased with their service, and if you need Motorcraft parts and can wait a few days, this seems to be a good deal.

------------------
'89 LX 5.0 - 5 speed. Original Owner
'94 E-150 4.9 Hi-Top Conversion Van

[This message has been edited by Maroon 5.0 LX (edited 10-03-2001).]

Coupe Devil · 10-03-2001, 09:46 AM

Thank you very much. You have just saved me a very obscene amount of money.

------------------
'93 lx notch 4 banger (drive it to work currently), Using the 306, 8.8 posi, 4.10's, summit rear cover, elec. fan, cowl hood, wieand stealth intake, holley 650 d.p.carb., built c-4, e-303, full autometer guages, msd box, mallory unilite dist, and coil, roll cage, summit seat, subs, 15x10's in the back with slicks, skinnies up front, all in use for 1988 Hatch Drag Car. Hope to start running next year. Hoping for 7.20's after all is done with small motor.

10-03-2001, 09:09 AM	#1
Maroon 5.0 LX Registered Member Join Date: Mar 2001 Location: Southern Maryland Posts: 471	My Good Experience With Ford Parts On Line - Good Discounts My hard-headed local Ford dealer would only give me 10% off on parts, so I tried http://www.fordpartsonline.com Ford Parts Online. Their web site is still being built, and is very slow. Here are a couple of sample prices for Motorcraft parts, which are pretty much in line with after-market prices: EGR - List: $127.33 My cost $74.49 O2 Sensor - List: $ 87.62 My cost $45.41 I ordered late on a Friday afternoon, and parts were shipped the following Tuesday. All done by e-mail, and they were pretty prompt replying. They do have an 800 number. Order was shipped UPS Ground, ($7.00) which took a week, unusually long for coast-to-coast shipment. May be due to aviation delays lately. (ground shipments do go on aircraft) All in all, I'm pleased with their service, and if you need Motorcraft parts and can wait a few days, this seems to be a good deal. ------------------ '89 LX 5.0 - 5 speed. Original Owner '94 E-150 4.9 Hi-Top Conversion Van [This message has been edited by Maroon 5.0 LX (edited 10-03-2001).]

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
rear suspension parts...did I do good?	gray87GT	Windsor Power	0	05-30-2001 04:09 PM
WINDSOR FORD HEADS ARE THEY ANY GOOD???	joey50gt	Windsor Power	4	03-22-2001 09:32 PM
Ford Motor is good enough for Chevy????	98yellow stang	Blue Oval Lounge	4	02-16-2001 11:13 AM
Good night at the track, but idiots wet down starting line	Rev	Stang Stories	7	02-11-2001 06:39 PM
Where is a good place to get interior parts from?	FastGTragtop	Windsor Power	0	01-12-2001 11:59 AM

10-03-2001, 09:46 AM	#2
Coupe Devil Moderator Join Date: Mar 2001 Location: Myrtle Beach SC Posts: 1,643	Thank you very much. You have just saved me a very obscene amount of money. ------------------ '93 lx notch 4 banger (drive it to work currently), Using the 306, 8.8 posi, 4.10's, summit rear cover, elec. fan, cowl hood, wieand stealth intake, holley 650 d.p.carb., built c-4, e-303, full autometer guages, msd box, mallory unilite dist, and coil, roll cage, summit seat, subs, 15x10's in the back with slicks, skinnies up front, all in use for 1988 Hatch Drag Car. Hope to start running next year. Hoping for 7.20's after all is done with small motor.