© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-10-2005, 07:53 AM | #1 |
Registered Member
Join Date: Feb 2000
Location: Newnan, GA, UnitedStates
Posts: 83
|
O2 Sensor
I have a 96 that is showing a lean (code 175) in bank 2. Ive replaced the o2 sensor , but i am still getting the same problem. When it is cold at start up it has a bit of white smoke, but once it runs for a few seconds( mabey 5 to 10) it stops. Any ideas on what to do?
__________________
92LX 5.0 Hatch,4.10 gears Auburn Pro,Mosser axels,alum drive shaft AOD hi ratio gear set,3200 stall TCI conv,Bassani long tube headers/cats,2 chamber flow masters,2.5inch exhaust,331 stroker,alum GT40 heads ported,Omega 1.7 roller rockers,JE forged pistons,Eagle rods,E cam,GT40 upper/lower intake,70mm mass,73mm Pro M bullet,MSD ignition,Cartech fuel sys w/external Aeromotive fuel pump,30lb injectors,Vortech S trim,Tubular front end,D&D coil overs up front |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
3.8 v6 cam sensor install | juggajuice | Small Ponies | 1 | 06-30-2005 08:34 PM |
I got a free mass air sensor | stevstum | Windsor Power | 2 | 05-27-2003 12:50 PM |
Whats the best way to tell if your running lean or rich? | K.C. 5.0 | Windsor Power | 9 | 09-10-2001 03:04 PM |
Sensor on Top of T5? | Green92LX | Windsor Power | 13 | 07-29-2001 10:11 PM |
Temp sensor question | RB92GT | Windsor Power | 2 | 06-23-2001 12:23 PM |