[ASSEMbler]

I just got a 200 v6 yesterday. A good price, and honestly all I could afford with the enormous insurance here in nj eating up the extra money I could have spent on a GT.

Please humor me.

I was offered a 3 inch mac cat back for a cheap cheap price. But now I am reading that it may be too much and I should go with a 2.5. Would it be a problem to throw the 3 inch on my car?

There'a a lot of kits on ebay that convert past the Y to a dual, but it seems more cosmetic to me.

In short: I need the best performance I can get at a good price with out going crazy. Instead of throwing all the money on more expensive parts for 1-3 hp when I could be a.) saving for a drop in motor solution or b.) saving for a GT. I wanted a GT but they were all beat to hell. For $8000 I got a 2000 with 20,000 miles. Not too bad considering my last car was an oldsmobile...

Ait intake: I can't just cut off that constrictive crap and put on a tube with a big filter, right? I assume the sensor would screw up the engine? I don't want to spend $$ If I am going to drop in parts from a donor GT I might get. It's a lot of work, but from $1800 a year to 7000 a year for insurance, I'd rather blow $7000 on parts and stil have the low insurance. I'd change the engine, computer, transmission and rear end , etc. It's a rolled cobra BTW.

Can I run a cobra engine on a GT rear end?