MustangWorks.com : Ford Forums - View Single Post - Please Help: How to pull Codes? '94 V6 Drop Top...

Faded · 07-01-2003, 11:04 AM

Hello, first post so please excuse the newbie question. I have a check engine light on my '94 convertable V6. My question is how do I pull the codes? I found a 16 pin connector behind the center console on the drivers side (it only has 6 pins in it). I'm assuming this is where you terminate to pull the codes, but I'm unsure which pins need to be jumpered (if these are the right ones). Someone please advise?! Any help is apreciated.

Thanks in advance,
Andrew

07-01-2003, 11:04 AM	#1
Faded Registered Member Join Date: Jul 2003 Posts: 5	Please Help: How to pull Codes? '94 V6 Drop Top... Hello, first post so please excuse the newbie question. I have a check engine light on my '94 convertable V6. My question is how do I pull the codes? I found a 16 pin connector behind the center console on the drivers side (it only has 6 pins in it). I'm assuming this is where you terminate to pull the codes, but I'm unsure which pins need to be jumpered (if these are the right ones). Someone please advise?! Any help is apreciated. Thanks in advance, Andrew