MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Small Ponies
Register FAQ Members List Calendar

Notices


Reply
 
Thread Tools Rate Thread Display Modes
Old 04-01-2003, 12:24 PM   #1
tilton
Registered Member
 
Join Date: Apr 2003
Posts: 2
Question Convertible top on 93 LX

Having a problem with top. Put the top down last week, then would not go up all the way forward to latch shut, stopped about 1/2 inch short.

After trying several times (5-6) lower and raising top, now the motor does not work at all. I checked the inline fuse and that is not burnt out. I hear a clicking noise when trying to engage motor. I'm thinking a relay switch?

Any advice on this would be appreciated.
John
tilton is offline   Reply With Quote
Old 04-04-2003, 01:14 AM   #2
84LX89GT
Mustangs
 
84LX89GT's Avatar
 
Join Date: Jul 2000
Posts: 1,938
Default

(These are in order of easyness

One test you may try is to take a piece of wire and jumper across the park brake switch (the only switch attached to the parking brake, should be easy to identify, but you'd have to remove your center console). It is a ground side switch and if you jumper accross the wires and the top works then it's likely a bad switch.......A much easier version of this test is to pull on the parking brake and see if the red brake light lights up in your dash.

Have you tried tapping on the motor with a blunt piece of metal like a hammer (don't beat it, just tap it). If you're hearing a click it means a relay is at least activating, although it may still be bad. The brushes in the motor may have gotten stuck/gotten corroded and can be jarred loose, or they may just be worn out in which case you'll end up following a few more steps..

Find both fuses and check them (you already found one was good). It is most likely the 30A fuse is dead or your motor is dead.

There are two relays, a lowering relay and a raising relay, that get main power from a 30 amp fuse, and get control side relay power (through the switch) from a 15 amp fuse. Most likely the 15 amp fuse is in the instrument panel, and the 30 amp is in the engine compartment. One test is to check on the other side of the switch while toggling it to see if the other sides get power. One wire should be constant, and the other two should be switched, the switch feeds the control side of the relays that make them activate (click).

Since there are two different relays and the motor doesn't work up or down it is less likely that both relays failed at the same time, it may be the case, but i'd look at other things first.

Have someone toggle the convertible top switch while checking for power at the convertible motor. There should be two wires sticking off of it. One will be energized with the switch activated and the other is grounded, they are both normally grounded through the relays, the switch energizes the selected relay and the 30A power source goes to the motor, then back through the other relay to ground. Have an assistant toggle the switch, once you get power on one side of the motor go to the other side and make sure that it gets power when the switch is in the opposite position from when you got power on the other side of the motor. I have enclosed a sample diagram of a mustang convertible top diagram (this is for a '94 mustang so it's probably got different wire colors).

Keep us posted, try these, then we can go onto more complicated tests like testing relays, the grounds, etc.

Good luck, hope this helps
Attached Images
File Type: gif convtop.gif (16.0 KB, 35 views)
__________________
2005 Suzuki Hayabusa GSX1300-R

1980 Ford Thunderbird - 255 V8
ported heads, 5.0L ported stock headers, O.R. H-pipe and Flowmaster 2-chambers, dual roller timing chain
hi-po Mack Truck hood emblem

1985 Mustang GT 5.0L T5, F-303, GT40p, headers, off-road h, flowmasters, MSD stuff, etc.

Sold 02/06/04
1989 Mustang GT ET: 13.304@102.29 mph (5-24-03)

Sold - 1998 Mustang Cobra coupe, 1/4 mile - street tires: 13.843@103.41 (bone stock)

Last edited by 84LX89GT; 04-04-2003 at 01:20 AM..
84LX89GT is offline   Reply With Quote
Old 04-04-2003, 09:14 AM   #3
tilton
Registered Member
 
Join Date: Apr 2003
Posts: 2
Default Bleeding the lines

Okay, I got power to the motor again. Was a circuit breaker.

Now I'm back to my original problem of the top not raising smoothly or evenly. I have checked and filled the fluid in the motor. Now in the process of bleeding the lines. This is very frustrating as I get fluid squirting everywhere!

I will admit that I am a novice at this car stuff, but am learning. I am trying to get my hands on a used shop manual, but these are hard to come by (I've checked online). I'm thinking there has to be a trick to bleeding these lines, it shouldn't be this difficult!

Thanks again!
John
tilton is offline   Reply With Quote
Old 04-05-2003, 07:26 PM   #4
84LX89GT
Mustangs
 
84LX89GT's Avatar
 
Join Date: Jul 2000
Posts: 1,938
Default

Glad to hear you found it! I've never had to bleed a convertible top, but i can imagine there has some way to do it Good luck
__________________
2005 Suzuki Hayabusa GSX1300-R

1980 Ford Thunderbird - 255 V8
ported heads, 5.0L ported stock headers, O.R. H-pipe and Flowmaster 2-chambers, dual roller timing chain
hi-po Mack Truck hood emblem

1985 Mustang GT 5.0L T5, F-303, GT40p, headers, off-road h, flowmasters, MSD stuff, etc.

Sold 02/06/04
1989 Mustang GT ET: 13.304@102.29 mph (5-24-03)

Sold - 1998 Mustang Cobra coupe, 1/4 mile - street tires: 13.843@103.41 (bone stock)
84LX89GT is offline   Reply With Quote
Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
I have an 1988 5.0 LX Convertible grant66 Corner Carvers Delight 6 08-17-2002 03:57 AM
Car Audio System in a 90 LX V8 stang convertible ziggy_2k Windsor Power 2 05-21-2002 12:33 AM
Roll Bar for Street Driven 92 LX Convertible RED92LX50 Windsor Power 7 10-01-2001 08:57 AM
'92 LX convertible wiring puzzle 92RedVert Windsor Power 4 09-29-2001 07:58 PM
Weight for 88 lx 5.0 convertible?? Z28EATR Windsor Power 3 02-27-2001 04:26 PM


All times are GMT -5. The time now is 03:31 PM.


SEARCH