Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-08-2003, 05:32 PM
|
#1 |
|
Registered Member
Join Date: Sep 2003
Location: Orange, TX
Posts: 360
|
CAI Installed Whew!?!
Installed MAC CAI this afternoon. Tried to install a throttle body spacer but on the 03 it just would not all fit in. Spacer was about an inch thick and could not get the piece between the TB and the Mass Flow to fit. It just could not get past the strut on the passenger side and then the fender well piece would not match up either. Had to take it back out. Any suggestions?
The air filter is also difficult to get installed. If I didn't have ramps to put the car up on I would have never gotten under the car in a position to get it in place. Wonder how often it needs to be cleaned? Every 10K miles? Wore me out but I can tell a difference in throttle response
__________________
2003 3.8 Mineral Gray, MAC CAI, K&N, Chin Spoiler |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| installed pa performance alt | GhettoPop | Windsor Power | 1 | 04-11-2004 09:42 PM |
| Eibach Springs Installed | COUSIN ROB | Modular Madness | 0 | 05-13-2003 09:17 AM |
| Just installed hawk pads........ | RPM427 | Windsor Power | 10 | 06-20-2002 07:22 PM |
| Getting Novi 1000 installed Wed. | Chris_H | Windsor Power | 3 | 12-31-2001 07:22 PM |
| Holley ignition, coil, and distributor installed..car won't start. Any ideas? | chadtn2 | Windsor Power | 5 | 08-13-2001 01:13 AM |