© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-01-2003, 11:04 AM | #1 |
Registered Member
Join Date: Jul 2003
Posts: 5
|
Please Help: How to pull Codes? '94 V6 Drop Top...
Hello, first post so please excuse the newbie question. I have a check engine light on my '94 convertable V6. My question is how do I pull the codes? I found a 16 pin connector behind the center console on the drivers side (it only has 6 pins in it). I'm assuming this is where you terminate to pull the codes, but I'm unsure which pins need to be jumpered (if these are the right ones). Someone please advise?! Any help is apreciated.
Thanks in advance, Andrew |
08-12-2003, 07:49 PM | #2 |
Registered Member
Join Date: Aug 2003
Location: Houston
Posts: 10
|
You might want to try this webb site:
http://www.cybrrpartspro.com/Manual%...delLookup.html You can input your make and model and go to the electronics portion and it should help.
__________________
TomR |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
O2 codes at open loop? | Nixon1 | Windsor Power | 6 | 04-24-2004 08:43 PM |
KOEO & continuous memory codes?? | Simi Stang | Windsor Power | 4 | 12-16-2003 02:37 PM |
Where do I put the jumper wire to pull codes on a 95 stang? | 93blkGTfun | Windsor Power | 3 | 05-12-2003 06:14 AM |
Need to pull codes. | The Deuce | Blue Oval Lounge | 2 | 09-20-2002 07:49 AM |
Why Wont My Car Pull Codes??? Anyone????? | BowTie Eater 5 Liter | Windsor Power | 5 | 07-26-2002 05:43 PM |