© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-25-2003, 03:15 PM | #1 |
Registered Member
Join Date: Mar 2003
Posts: 2
|
1997 Head Gasket
I think the head gasket is out on my 1997 mustang, 6cyl.... It runs for a while, then runs hot, then smokes. I've since left it sit, but I don't know what I should pay for a new head gasket.
Also, does anyone recommend any shops in Denver that know what they are doing? |
03-25-2003, 05:47 PM | #2 |
College Stanger
Join Date: May 1999
Location: Aiken,south carolina, usa
Posts: 1,097
|
It is VERY expensive. It will cost you $0.00. Call your ford dealer and tell them. There was a recall on 1994-1998 3.8L V6 cars because they blow there headgaskets. Ford should replace them for free. I did mine before I knew about the recall and the reimbursed me $450. Good luck man.
__________________
2003 Sonic Blue Cobra |
03-28-2003, 04:28 PM | #3 |
Registered Member
Join Date: Mar 2003
Posts: 2
|
Hrm.... One garage said that it was only 95's that that applied to... antoher said it was not applicable to my VIN number... Hrm..
Are they giving me the run around, or am I stuck with a lemon w/ 70K miles? |
03-29-2003, 08:43 AM | #4 |
College Stanger
Join Date: May 1999
Location: Aiken,south carolina, usa
Posts: 1,097
|
They are giving you the runaround because myine is not a 1995 and Ford reimbursed me.
__________________
2003 Sonic Blue Cobra |
03-29-2003, 08:58 AM | #5 |
College Stanger
Join Date: May 1999
Location: Aiken,south carolina, usa
Posts: 1,097
|
I swore that it was 94-98. But all the info I found looking now says that it is 94-95 and must be with in 7 years of the car being made and must be under 100,000 miles.
__________________
2003 Sonic Blue Cobra |
03-29-2003, 02:44 PM | #6 |
Registered Member
Join Date: May 2002
Location: Tampa,FLORIDA
Posts: 340
|
I checked for the wifes 97 3.8 and they found no recalls on it either. I checked with two different dealers.
__________________
5.0, Holley heads, 1.7 Scorp Rockers, Stealth intake, Holley 600 carb, Holley Mech. Fuel pump, MSD 6Digital, MSD distributor, Hotchkis upper/lower rear control arms, FMS B Springs, 3:73 (8.8) rear. Production # 9,377 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Could a head gasket cause a tapping? | Michael Smith | Windsor Power | 13 | 09-27-2004 07:10 PM |
302 head gasket | ponydude | Classic Mustangs | 1 | 07-26-2001 07:37 PM |
Which Head Gasket should I use? | capri302 | Windsor Power | 1 | 05-08-2001 05:33 PM |
head gasket replacement stuff questions | fiveohpatrol | Windsor Power | 4 | 04-13-2001 04:23 PM |
Head gasket choice for AFR 165's on N/A combo | cojonepony | Windsor Power | 1 | 03-28-2001 08:30 PM |