
                    © Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
                    
                  
                MustangWorks.com is designed and hosted by Aero3 Media.
| 		
			
			 | 
		#1 | 
| 
			
			
			
			 Registered Member 
			
			
		
			
			
			Join Date: Mar 2004 
				Location: Long Island 
				
				
					Posts: 58
				 
				
				
				
				 | 
	
	
	
		
		
			
			 whats up guys, about a month ago i installed a tremmic 3550, on my 90 5.0. when taking my clutch off i noticed a few of the springs we loose ??? not really loose , but if i shook it i would hear a little rattling . i didnt have the dough for a whole new clutch, so i just got my pad relined. when i took my pad to get relined i asked the clutch shop if that rattling is normal , an he said ya thats ok...     
		
	
		
		
		
		
		
		
			Now just a couple of days ago i noticed a rattling noise comming from underneath the car. but only at low RPMs when i would hit the gas it would go away i thought my exhuast was just rubbin on somthing, i took my car to my friends shop jacked it up, and the rattling is comming from my bell !! could those clutch springs have gotten a looser ? and if it did do i have to replace the whole clutch ? i thought also maybe a clutch bolt fell out ? but wouldnt my car vibrate alot if that was the case ??? any suggestions would be great ! thanks -dave 
				__________________ 
		
		
		
		
		
		
	
	1990 Mustang GT Engine- 308 (bored .40 over) Probe Forged pistons (10.5:1), Scat forged crank and rods, w/Main Girdle, AFR 185 heads, GT-40 intake, CSI electric water pump. AC delete kit, No smog pump, Manual rack and pinion steering. Ignition- MSD 6AL, MSD Blaster coil, MSD hellicore wires. Drive Train- Tremic 3550, Alum. Drive shaft, 3:73 gears, Stock carrier and axels. 26X11.5 M/T Et streets. Power adder- 175 shot of laughing gas. Best ET 11.5 @120mph on squeeze, 12.4 @109mph on muscle (on gt40 heads) on the 185 heads ... ??? tba  | 
| 
		 | 
	
	
	
		
		
		
		
			 
		
		
		
		
		
		
			
		
		
		
	 | 
		
  | 
	
		
  | 
			 
			Similar Threads
		 | 
	||||
| Thread | Thread Starter | Forum | Replies | Last Post | 
| bell housing for tremec | COBRA66 | Windsor Power | 0 | 12-20-2002 04:00 PM | 
| need help with c4 bell housing | wes hall | Windsor Power | 2 | 12-06-2001 11:42 PM | 
| C-4 Bell Housing? | john_86stang | Windsor Power | 0 | 02-16-2001 09:15 PM | 
| Bell Housing 4 T56 trany | St_Brawler | Modular Madness | 3 | 06-20-2000 12:35 PM | 
                    
                  