![SEARCH](http://www.mustangworks.com/images/search.png)
![The Mustang Works](http://www.mustangworks.com/images/mw_footer_logo.gif)
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: May 2001
Location: St. Joseph, MI
Posts: 33
|
![]() hello, I just got my car out from winter storage. At 80-85 mph I am noticing a large vibration comming though the shifter handle. It feels like the drive shaft or u-joints may be bad or out of balance, and body ever expeirience this before?? thanks a lot, Scott
__________________
1994 mustang gt Zex 75-125 shot, BBK equel lentgh headers, off road x-pipe, flowmaster 2 chamber. bbk underdrives, FMS 3:73, MSD 6al ignition, BBK cold air induction, 70mm throttle body, C&L mass air, K&N cone. Pro 5.0. 96 corba rear buber, 1998 cobra wheels 17/8, BFG Comp TA ZR 275/40 rear,245/45 front Best ET 13.24@105.5 |
![]() |
![]() |
![]() |
#2 |
Registered Member
Join Date: Oct 2002
Location: illinois
Posts: 26
|
![]() Well it could be the u-joints, or it could be the drive shaft is out of balance, or it could just be that you need to tighten the bolts that hold the drive shaft on. Most likely in my past experiences it's been the bolts and the use of thread locker before I tighten them keeps them from working loose.
|
![]() |
![]() |
![]() |
#3 |
Registered Member
Join Date: Mar 2003
Posts: 25
|
![]() my buddy had an 1989 gt and he complained of the same vibration that u have described. He installed an aluminum driveshaft and new u joints and it fixed the problem.
|
![]() |
![]() |
![]() |
#4 |
Registered Member
Join Date: Mar 2001
Location: Southern Maryland
Posts: 471
|
![]() Did it sit on the tires while stored? If so, probably just flat spots on tnem, and should work themselves out in time. Mine does that after it sits a few weeks, especially if it's cold.
If the problem didn't exist before you stored it, it's hard to believe a hard part, a drive shaft, U-joint, etc would all of a sudden go bad.
__________________
'89 LX 5.0 - 5 speed. Original Owner '94 E-150 4.9 Hi-Top Conversion Van '06 Mustang V-6, 5 speed Last edited by Maroon 5.0 LX; 03-31-2003 at 07:27 PM.. |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
1996 Cobra vs 2000 Mustang GT | Milktasd | Stang Stories | 2 | 04-05-2002 03:11 AM |
RESULTS - Grand Prix GT vs. Celica GTS | 302 LX Eric | Stang Stories | 7 | 09-25-2001 06:46 PM |
ran a '01 GT | EZRIDN | Stang Stories | 3 | 08-29-2001 08:17 PM |
Whooped an '85 GT with my Wife's Volvo | NO SLO PK | Stang Stories | 8 | 07-20-2001 12:46 PM |
Moroso results w/ stock 207K '87 GT | EZRIDN | Stang Stories | 3 | 07-12-2001 03:58 PM |