Paint chip repair : Please Help!
 

Hi,
I posted in Blue Oval Lounge cuz the Appearance & Detailing section doesn't get much posts. Anywho, hope someone can help me.

I have several hairline cracks and one big chip on my car; these cracks/chips are all down to bare-metal. I am currently planning on touching up these problems and would like to know the process involved in doing the job right. So far, here's the process I'm thinking of doing:

• Use spray cleaner to clean area
• Sand edges with 220 grit
• Use spray cleaner to remove particles
• Use 400 grit to sand painting area
• Use spray cleaner to remove particles
• Paint with primer and let it dry for 2hrs
• Sand with 600 grit
• Repeat last two steps for 2-3 coats of primer
• Paint area and let it dry for 2hrs (do this with 5 coats)
• Paint area with clear coat and let it dry for 2hrs (about 2-3 coats)
• Wash/Wax car after a week or so

I dunno if I should dry/wet-sand after last coat of paint, and then dry/wet-sand again after last coat of clear coat.

Also, is it ok if I use spray cans (of primer, paint, clearcoat)? I'm not aiming for showroom quality job...jsut something to hide the cracks/chips.

Does this plan sound just about right? I left out such things as the tools involved (that is all covered)...just the preppnig and process I'm a litlt rough about.

Please help!

Thanks!
Bye!


------------------
Gautam N. Lad
http://www.cubicdesign.com
http://www.cubicdesign.com/mustang/

[This message has been edited by Gautam (edited 04-22-2001).]