1.6 rockers, will the stock valve cover work?
 

Well I am just making sure I have everything set before I do the head and intake swap, and my question is will my stock valve covers fit with my GT-40 P heads and 1.6 roller rockers, except for the need to plug the a/p holes in the back of the heads with plugs.Thanks...

------------------
91 LX Convertible Gray on Red B&M Shift improver kit,ASP red alum. underdrive pulleys, Richmond 3.73 gears, 1 5/8 Flowtech long tube Headers and off road h-pipe, Flowmaster 2-chamber cat-back with S.S exhaust, MSD 6A Ignition with coil,Cap and rotor, Taylor Pro wires, K&N 12" conical filter system, Jet stage 2 performance chip and just purchased some GT40P heads, looking at exhaust, Lentech Street Terminator plus on it's way...

You should be alright being that the factory ratio for the rockers are 1:6's. I buddy did the roller swap and he just put his stock covers back on.

I have never done it but I have read about it a few times. If you are putting 1.6's on stock heads they fit but you may have to grind a bit here and there, and I am pretty sure you have to take off the shield at the bottom of the fill tube on the inside. You may want to check around to save some headaches. I am sure alot of people here have actually done it and know alot more than I do. There is also someone here with a GT-40P head website. I'd look into it.

------------------
86 GT T-tops, AOD, B&M shift kit and hammer shifter, ROH wheels, K&N, Timing,MAC headers, 2.5 off road H, 2.5 American Thunder, 87 spindles, rear disc,SS lines, BBK 1.5, poly bushings, Steeda G-trac and subs, Strut bar.
"DRIVE LIKE YOU STOLE IT!"