Porting stock heads
 

Has anyone ported their stock heads by themselves? Do you have pics of the job? Can you use a Dremel? What areas do you have to smoothen out, and how much do you smoothen out? Would I notice a good gain in power? How long would the job take? Thanks a bunch

------------------
96 GTS, 4.6L, 5 spd, MAC cat H-pipe, straight pipe mufflers, 3.55's, pulleys, WMS Velocity Tube w/87 mm MAF, Steeda Tri Ax

[This message has been edited by Dino (edited 01-09-2001).]

you know what, its not even worth your time. You are better just saving up $700+ and getting a set of the 99+ heads and bolting up a true 35-40HP. Tell you what, port those babies and then you'll have spent your money and time well!