Stock Specs
 

I'm actually starting to get serious into suspension design. Being the Mustang is the car I have to work with, I'm looking for some stock specs on the front suspension. Such as the deminsions and placement of the lower A-arm, scrub radius, roll center, ect.

Does any one no of any resources where I could find this information, or do I just need to get the tape measure and figure it out?

Thanks.

Here are a "few" (ok, TONS) of specs for ya... http://members.mustangworks.com/drudis/mustang/must98/

------------------
Darius Rudis
Roadracer: Home built t-arm/panhard suspension powered by an S-trimmed motor :-)
My Mustang Page