Swap SN-95 interior into FOX???
 

Can you swap the interior from any 94+ Stang into an 88 Notch? I am mainly interested in the dash and center console.

If you have any pics or info please let me know.

Thanks

------------------
C ME FLY
88 Notch
MAC headers, H-pipe, and Chrome 2.5" pipes, pullies, K&N filter, BM shifter, 17" ROH ZR6, Dropped 1.5".

wondering that myself...only want the 98? center console in my 95, I like the cup holders...can that be done?

I was told on an earlier post that the front seats could be swapped over. My 90 Notch has the famous sagging drivers seat

------------------
Frank W
90 5.0 LX coupe Stone stock Two Broken T-5's at the Trans shop now. First Mod removed Silencer at 99,614 miles.
74 Chevy Laguna Type S-3 305 apart in garage, getting a 454 to put next to it
www.chevellepages.com/folingo

ttt

ttt,
anybody know of these interior swaps?
94+ into an 88 - interior parts
98 into a 95 - this, just the center console

Anything's possible... but I think the SN95 might be an inch or so wider than the fox.

So my question about the 98 into the 95 should work, then, huh? I really miss having cup holders...

Chevyguy: Is your floorpan torn? That's usually what causes a sagging seat in a Fox.
My 79 Pace Car had about a 6" tear in the floor pan where the right rear stud on the seat goes through...

I have 98 front seats in my 89 notch and they fit fine. but the rear seats don't fit at all

My floor appears to be perfecly intact. I was told to look out for cracked seat mounts due to racing launches etc.
The seat back is sagging on the right side, my 91 was doing this after 20,000 miles. I have seen many other Mustangs with this droopy drivers seat.

------------------
Frank W
90 5.0 LX coupe Stone stock Two Broken T-5's at the Trans shop now. First Mod removed Silencer at 99,614 miles.
74 Chevy Laguna Type S-3 305 apart in garage, getting a 454 to put next to it
www.chevellepages.com/folingo

My driver's seat sags a lot too. There isn't anything wrong with the floorpan, or the mounding studs, I took the seat out, and its the seat back. Couldn't figure out exactly where the prblem is, so I was unable to fix it, but its within the sat itself. If you are looking down onto the seat from overtop the car its torqued clockwise, I assume like everyone else's.