MustangWorks.com : Ford Forums

MustangWorks.com : Ford Forums (http://forums.mustangworks.com/index.php)
-   Windsor Power (http://forums.mustangworks.com/forumdisplay.php?f=8)
-   -   Codes (http://forums.mustangworks.com/showthread.php?t=17081)

pac663 12-06-2001 02:09 AM

Codes
 
Continuous codes 22 Map/BP Out of range. 67 Neutral Drive SW Open or A/C on. The 67 code is a on demand code Engine off self test. I got this print out during the dyno run. Thanks.

PKRWUD 12-08-2001 06:28 AM

Are you experiencing any drivability problems? Does the MIL come on at all? I would disconnect the negative battery cable for 15 minutes, and while it's disconnected, turn on your headlights to drain any capacitors. Then reconnect the battery and check for codes again.

Take care,
-Chris

pac663 12-08-2001 01:02 PM

What is the MIL? I'll try the batt. and headlight thing and let you know. The check engine light has been on for some time,right after I installed the 70mm tb. Thanks.

PKRWUD 12-08-2001 01:23 PM

The MIL is the Malfunction Indicator Lamp, aka check engine light.

Take care,
-Chris

pac663 12-10-2001 10:20 PM

Hey Peck, I tried your tip, no dice. The only driveability problems have been idle surging but, that just started. The MIL has beed on for some time. Fuel was coming out of the fpr(is it time for a new one?) when I took the vacuum line off. Thanks!

PKRWUD 12-11-2001 08:03 AM

If fuel is coming out of the vacuum port on your fpr, YES you need to replace it. Think about it. Your sucking unmetered fuel into your intake.

Take care,
-Chris


All times are GMT -5. The time now is 12:19 AM.