Question about my new C&L 76mm
 

Yesterday I got the new 76mm C&L MAF and I finally got a chance to put it on this morning when it quit raining. Well, after I started the car, it idled really low (about 600rpm)and the vacuum was about 6 in. HG's. After I let the car get up to operating temperature and pulled out of the driveway and down the road, it had absolutely NO power. Instead of revving, it kinda buzzed its way up to 2500RPM, then kicks in with a little more power. It kinda sputtered and buzzed for about ten minutes until the problem gradually went away. So, after the engine got good and warm, it stopped. I am wondering if this is because the computer hasn't had time to adjust to the new settings or if this is a problem with the calibration of the meter. Anyone have any ideas? I have the battery unplugged letting the computer reset.. I hope this helps.

------------------
MAC equal length headers, MAC Off-Road H-Pipe, Flowmaster mufflers, 373's, March ram-air kit, underdrive pulleys, 73mm MAF, 75mm TB, Saleen Intake (ported), Edelbrock 6037 heads (ported, polished, 3 angle valve-job 255CFM @.500), 1.6 FMS RR's, Wolverine 1087 Cam, 24lb injectors, MSD 6AL, Subframe connectors, Griggs Adustable Lower Control Arms, Lakewood 50/50 shocks, SSM Upper Control Arms... and probably some more in there I forgot

Did you reset the computer before installing? I let mine sit for quite a while after installation since it only too a few minutes to do. Make sure you didn't damage the MAFS probes and that its plugged in completely. Also, be sure that there aren't any leaks (hose clamps tightened good).

Love mine! Works great!

------------------
Brad
Stock '89 LX 5.0

Also, make sure the MAF connector is on tight, and that no other connectors were knocked loose during the installation.

------------------
Russ L
'91 LX
Procharger, 3 row intercooler, extrude honed Cobra intake, Mac full Length Headers, 30# inj., 73mm C&L, 75mm tb, E303 cam, 289 rods, ported E7 heads, MSD, T-Rex w/255 lph Walbro, 5 lug conversion, Cobra R wheels, 3.27 gears and Moser Axles.

Thanks for the input guys! I think I will go out there and check everything real good tomorrow. It is supposed to be great weather and I think it is going to be a good day to do a little work on the car. It very well could be any of those things you mentioned. I'll give it a good looking over. Thanks again.