Anyone Have Oictures Of The Passanger Side With BBK 1-5/8 Equals???
 

I put mine in, and my smog stuff is hitting the headers, so I was wondering if any of you have pictures of that side so I can compare, and see what I did wrong???


Thanks

Where is it hitting at? And do you have them installed or are you trying to install them? I do know mine were real close after I got them installed.

I just used a couple of zip ties to hold my smog stuff of the headers, Another problem you will have is your #4 plug wire getting burned by the header.

Its an easy fix,

Good Luck,

well, the full exhaust is on the car right now, and i will use the wip ties.

i took off the aluminum tube that goes to the h-pipe (smog pump thing that shoots air into the cats), and i am not sure if i will have to duct tape the valve thing from where i removed the tube???

PLEASE HELP!!! CAR WONT START!!! NEED HELP BY TOMORROW MORING...
 

i know my distributor is put back incorrectly,(yes, i realise that that was a dumb-*** thing to do, not mark it) and it wont start(the rotor got turned while it was out for the oil pump change)

what is the easiest way to get my car to start again???

(Unit5302 gave me a methd i may use if i dont have any other replys by tomorrow morning)

Get your car on Top dead center or TDC and drop the distibuter back in with the rotor facing the #1 plug.

Then double check your plug order.

P.M. me if you need any help or E-mail me @ Whitesteel23@hotmail.com

just remove all the smop pump stuff, it really cleans up the passenger side. Pump, valves, hoses, vacuum lines, diverter valve, tube to heads and exhaust, get rid of ALL of that crap.