Please Help!!! Car Wont Start!!! Need Help By Tomorrow Moring...
 

i know my distributor is put back incorrectly,(yes, i realise that that was a dumb-*** thing to do, not mark it) and it wont start(the rotor got turned while it was out for the oil pump change)

what is the easiest way to get my car to start again???

(Unit5302 gave me a methd i may use if i dont have any other replys by tomorrow morning)

I replied on your other post.

1) Pull #1 spark plug.
2) Wad up a kleenex and stuff into spark plug hole.
3) Crank engine by hand until kleenex pops out of spark plug hole.
4) Rotate engine by hand to align timing mark on balancer with 10 degree timing mark (it should be VERY close when the kleenex pops out)
5) Adjust (turn) distributor until #1 plug wire terminal lines up with rotor.
6) Tighten the distributor and fire it up.

Take care,
-Chris