Oil Pans
 

I have a 1993 GT 5.0. I am doing a number of modifications and one is to upgrade the oil pump and oil pan. I have purchased a Moroso oil pan pant number MOR-20511 and when I received it I noticed it does not have the plug to re-install the low oil level sensor. Did I order the wrong oil pan or do I need to modify it? Has anyone crossed this bridge before? By the way, I am also installing the FMS high volume oil pump.

My Canton 7qt doesn't have the provision for the oil level sensor either. I didn't modify my pan to accept it, I pulled the bulb in the dash and clipped off the wires since I never planned on running it again, all my stock one did was leak and make a mess even after replacing the seal.

------------------
My Ride Check Out My Site 91GT, Holley SysteMAX II Kit-Heads 2.02" x 1.60",Full MAC exhaust 1-5/8" Long tubes, 2-1/2" O.R H-Pipe, 2 1/2" cat back, 12" K&N Filter, RNH PERFORMANCE Ram Air, Ron Davis Radiator, Full Suspension,3:73's, Welds, Best on new motor-12.60 @ 108, no traction 1.98

Ditto on the Milodon pans, I just clipped my wires and the light never came on.