Calling anyone who relocated the MAF Sensor
 

Did you make you own extension harness or did you buy one, If you made it what type of connector would you recommend?

(I hate electrical and any thing that will make my life easer I need to know about. That’s why I wanted to buy a pre-made harness)

I know that Interactive Systems & Technologies makes one but I think they went out of business, or something because no one has been returning my calls

I moved my MAF sensor to the drivers side fender well to make my procharger setup a suck through on the MAF, rather than a blow through running a 80mm C&L Meter

I made my own.
Cut the wire between the connectors, then soldered 12" of wire, heat-shrink tubing, little electrical tape...
http://www.dariusrudis.com/mustang/engine/maf.jpg

I bought one from Teaxs Mustang. I hate cutting factory wires I think it was around $20.