what do you think this combo will run???
 

Well to make myself feel better I made out a mod list for when I get my 5.0 swaped in. What do you guys think this will run on street tires? What about D/R's or slicks? Here goes:

Ported E7's
Ported stock intake
Steeda #18 cam
1 5/8" long tubes
off-road H-pipe
MAC cat-back
65mm throttle body
73mm mass-air meter
cold-air induction
power pullies
130 amp alt.
king cobra clutch
Pro 5.0 shifter
3.73 gears
south side lift bars
boxed torque boxes
boxed upper control arms
sub-frame connectors
a 100hp shot of nitrous

What do you guys think this will run on the motor? What about on the juice? I might run a 150hp shot, what kind of times do you think that will turn? Any suggestions or comments you wanna make?

I say 13.2's on the motor, depending on how crazy you get with the porting, stock valve size and stuff, if you upgrade valves, and run 1.7 rockers, id say a real low 13 at 104-106...on the juice 11.50's at about 118, just my .02, i could be way off. good luck sounds like a pretty mean combo.

I was only looking for a high 11 or low 12

but a 11.50 would be nice, hehe:D

How low can you go?
 

Low 13's on the engine alone, mid-to-high 11's on the 150 shot.
D/R's or slicks are a must.

The only thing that I didnt like about your suggested combo is the "ported stock intake"........The Explorer GT-40 intake would be a much better choice and you can pick one up for about $200.00......

Later,