MAF will it fit?
 

my friend offered me a good deal on a C&L 76mm Mass Airflow will it fit my 94 cobra?

YOU WOULD HAVE TO MAKE YOUR OWN COLD AIR KIT, OR TAKE YOUR MASS AIR BOX OFF AND TRY TO PUT A HOSE BETWEEN THAT AND THE K&N. IF ITS THE METAL INLET TUBE WITH THE MASS AIR, IM NOT SURE, BUT I DONT THINK THE INLET TUBE WILL FIT.

So you have a 94 Cobra, and your buddy is offering you one out of his Cobra? I assume it is calibrated for the 24# injectors.

If the the MAF fits the stock air box you'll have a flange on the inlet side. If he had a Cold Air Kit you will be OK. I guess you could make an adpater to fit if all else fails (a flange with a land to put a hose on).

he doesnt have a cobra and i dont know how it is attacked, but it is setup for 24# injectors

If it's just the MAF (not the tubing) you're fine. Even if it has tubing, you should be able to remove it from the MAF housing. Make sure it's set for 24lbers.

i was worried it wouldnt, because when i was looking at them online it says for 86-93 5.0L...

you use your own sensor with the c&l so make sure the sample tube is for 24# injectors, so just switching the sensor isnt going to do anything.

The cobras computer compensates for the larger injectors so you need a sampling tube for 19 lb. injectors.

RYAN