How to remove door panel in '89 5.0L?
 

Hi,
Ok, my driver side door is b*tchin around and it's sometimes hard to open the door (unless you fiddle with it). It's a bit easier to open from outside, then it is from inside. I just noticed this today, and I'm getting annoyed. http://www.mustangworks.com/interact...gboard/mad.gif

I think my lock/unlock switch is damaged or soemthing and I think it'd help if I can remove the door panel to see what I can do to fix things.

How do I remove the door panel? Where are the screws located? Is there any precautions I should take before popping off the panel? Would it be just as easy to put it back in?

Thanks!
Bye!


------------------
Gautam N. Lad
http://www.cubicdesign.com
http://www.cubicdesign.com/mustang/

The door panel is pretty easy to come off. Just make sure the speaker is unscrewed, and the door handle, and the arm-rest. Once thats done all you'll need to do is get a wide screwdriver and at the bottom (better at a corner, front or rear)stick it between the door and the panel. Gently pry off the panel, its just held on with plastic mushroom-heads. They are only on the front, bottom, and rear of the door. Once all the plastic mushroom-heads are out then lift the panel up, cause its in a groove up top by the window channel. Thats it! Reverse order to put it back on.

Phantom