I have the DYNO Sheet!!!!!!
 

Here is my Dyno Sheet from Cerra Racing
The Frst Run there the lower one is the as I brung My car in the better one is after the trune up from Mike Carra.
http://63.251.78.219/Image%20file/Dyno/DSC00970.JPG

The car is running too rich especially in the lower rpms! Sounds like you need to turn down the FP. Ideally, you want a 13.2-13.5 a/f ratio @ wot for a n/a car. There is more power in it w/ tuning, how much I dont know. How is the tune set up now?

Rember I am speed Denscity it will run rich when it is At low Rpms with out bruning a new chip...

still kinda funny that I was making power at 6k with the same cam, rockers and heads.. still pretty good numbers... better than my carbed ones ;-)

you have GOT to get that swapped over to mass air and get an aggressive cam in there.

Go after an Ed Curtis cam, and you'll see over 300rwhp.

have you had it to the track yet?

well I cant wait to get the NO2 on it I have a 75 shot and will work to get a bit more power out of it has it is.

you'll have fun when you run it... should pull at least 103-104 in the 1/4... ;-)

I agree. It is a tad rich, but nice numbers for sure!

Nice number indeed. Especially since SD can't take any mods, hehehe. You're just another SD guy to point to when that comment pops up. You do realize that right? :D