which gaskets for BBK shorties?
 

im piecing together stuff to replace my head gaskets and need to know which header gaskets to get, thanks

------------------
88 Notchback 5.0, 3.73's, Explorer intake, pulleys, Crane 1.7's, BBK headers, off-road H-pipe, flowmasters, subframe connectors, 65mm TB, shift kit, March ram air kit, motorsport wires, MSD coil, upper and lower control arms, 155lph fuel pump, cheap 2800 stall, Crane Adj.FPR, best time- 13.99@99.75, not yet tested times after rocker and intake install

I am pretty sure you can get header gaskets from BBK.


------------------
'82 GT 351W C-4,BBK headers,Carter 625 carb,Comp.Cam,Flowmaster exhaust.
1988 GT...T-5,bone stock

any header gasket for a 302 will work. they dont make special ones for BBK headers.

------------------
1993 GT/AOD
'93 Mustang GT

Just get teh small block for header gaskets. DON'T use the ones they send you, the will leak like a ***** !

------------------
87 GT, 4 inch cowl hood,17x9 Cobra R's/255/45's,GT-40 heads,long tubes headers,h-pipe,Flows,BBK cold air, Mass air,70mm MAF, 1.7's, 1" spacer,underdrive pulleys,Pro 5.0, King Cobra, Adj. fuel Reg., Lakewood Lift Bars,50/50's,subframes, 4.10's.
Best time 12.96
Best MPH 103.42
Best 60' 1.695

Visit my site at:
http://www.geocities.com/cobrar93_2000/MyPage.html

93CobraR, did you know if you soak header gaskets in water before you install them that you will get a much better seal? It's true because it softens them up and the headers get a better seal. It has always worked for me.
Mach 1 is right, you can buy gaskets for a 302 and they will work.


------------------
'82 GT 351W C-4,BBK headers,Carter 625 carb,Comp.Cam,Flowmaster exhaust.
1988 GT...T-5,bone stock

I used the Fel-Pro (1450 I think). As long as you torque them evenly and keep the bolts tight they don't leak.