TFS TW, milling 1.7's and E303
 

Im surfacing my TFS TW heads. I believe the max lift is .535? or .530? Im going to run E-303 w/ 1.7s which is 530 lift?

AM I safe?

Skyler

Dude, the lift would be like .529. It should work fine. But, to be sure just clay your pistons. Good Luck.

-Billy

You shouldn't have any problems...if i was you why not change cams? The E-303 isn't that good of a performance cam. Try the lunati 2031 or something of that nature..I think you'll be more happy.

Eric

Some people run pretty decent with an E-303 cam. :D

The max lift for TW's is .540 if I remember correctly. My heads have been resurfaced twice, and I use the E-303 with 1.72 Motorsport (Crane) Rockers, and a 6.70 inch pushrod. No clearance issues here.

Sounds good thats what I was looking to hear.