Simple tech ? for you guys....
 

Sorry, this one's not about a race......could you tell me (based on my current mods) what my fuel pressure psi should be set at? Thanks for your input.

------------------
'90 LX 5.0; 12K original miles (no sh*&); 3.55 gears; pulleys;Edelbrock Performer Heads; BBK shorties; MSD 6AL box w/ blaster 2 coil; Motorsport E303 cam; Pro-M 75mm MAF; BBK 70mm TB; Eibach spring kit; Southside welded subs; K&N cone filter charger; Hurst shifter; fiberglass turbo hood; A/C-less; rear seat-less; cat-less; 2 chamber Flos; Corbeau racing seats (fronts);
30# injectors; 190 lb fp; FPR; TFS track heat Intake - 12.513 @ 112 mph (Pre-inj/fuelpump/FPR/intake)

Moved to Windsor Power

------------------
SVO siamesed 351 stroked to 417ci,Yates heads, solid roller,Trans King glide and a little blue bottle
of giggle gas. My Car

?

------------------
'90 LX 5.0; 12K original miles (no sh*&); 3.55 gears; pulleys;Edelbrock Performer Heads; BBK shorties; MSD 6AL box w/ blaster 2 coil; Motorsport E303 cam; Pro-M 75mm MAF; BBK 70mm TB; Eibach spring kit; Southside welded subs; K&N cone filter charger; Hurst shifter; fiberglass turbo hood; A/C-less; rear seat-less; cat-less; 2 chamber Flos; Corbeau racing seats (fronts);
30# injectors; 190 lb fp; FPR; TFS track heat Intake - 12.513 @ 112 mph (Pre-inj/fuelpump/FPR/intake)

I would start at 38-39psi with vacuum off and go up in 1/2lb increments until you feel the power drop off. Make sure you read the plugs right after running hard not after idle, this will tell you if it is rich or lean. I was running 42psi with my set-up, before the custom cam or ported heads.

------------------
Check Out My Site 91GT,Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to a 1262,Anderson N-61,24#,76mm C&L,Full MAC exhaust 1-5/8" Long tubes,2-1/2" O.R H-Pipe,2 1/2" cat back, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radiator,Full Suspension,S&W 8pt "X" brace,JAZ seats,3:73's,Welds..etc,4:30's and 31 splines coming very soon!