mass-air meters
 

hi guys, right now i have a 75 pro m bullet, i would like to upgrade to a 77 pro m or a 76 c&l. can i get any suggestions? 91LX, 306, tfw heads, gt40 intake, 70tb, e303, 3.55 gears, X pipe, bbk long tubes, t5z, hv oil pump, 190 fuel pump, #24 injectors, msd, THANKS!!

C&L's require that you still have the stock MAF sensor electronics. I had to go to a used parts store to get one. It was $25. We're only talking about a couple mm here and if you don't plan to change injector size, the 75mm bullet should be fine for you. The nice thing about the C&L 76mm that I got is that you can recalibrate it for a lot less than the Pro-M and you can get it as part of a kit with that great intake pipe for about $200. It's a real tight fit to get that intake pipe installed. Some "finessing" of the strut tower may be necessary to get it to fit easily. Use Ford special tool #H-32588 below:

http://www.cwikship.com/cwikship/ima...dge.hammer.jpg

:D

i agree with jimberg, dont waste your money. its not going to help you out with power by moving up a few mm's.
take care,
adam

Thank you guys, now that you guys said that I think I spend some money on gears(373 or 410 ??) I now have 3.55, also 1.7 rockers(o.k. with ecam), thanks again!!

good move

adam