MustangWorks.com : Ford Forums

MustangWorks.com : Ford Forums (http://forums.mustangworks.com/index.php)
-   Modular Madness (http://forums.mustangworks.com/forumdisplay.php?f=17)
-   -   03 cobra Hopup parts (http://forums.mustangworks.com/showthread.php?t=26811)

Doug McGinn 07-28-2002 04:45 PM

03 cobra Hopup parts
 
I need help locating the following parts for a 2003 Cobra.
Any links you can send me or post would be greatly appreciated.

1. Blower pulley
2. Catback Exhaust system (not steeda)
3. H pipe
4. Cold Air Intake setup
5. Performance chip
6. Drag Radials (current tires are 275/40zr17)

Also i was wondering how the steeda exhaust systems compare to others like Flowmaster and MAC as far as horsepower and sound.What are the effects of using an offroad H pipe without Convertors or potential problems?

My Email is RedCobra@cox.net

VeNuM 07-28-2002 05:19 PM

1. try using a SVT Lightning pulley
4. http://www.uprproducts.com/shopping/shopexd.asp?id=371
If you don't run cats, you will get better performance and a louder, deeper sounding exhaust. Only thing is you can't pass emissions.

Doug McGinn 07-28-2002 05:27 PM

problem with using the lightning pulley is theres no way of knowing what your final boost figure is going to be.
I dont wanna spend 200 bucks on a pulley and then blow the heads off my engine.

VeNuM 07-29-2002 03:44 PM

Try these guys then, http://www.southfloridapulleyhq.com

46stang 07-29-2002 10:19 PM

i just installed the south florida pulley system on my car and wow it pulls much harder now! I'm going to try and get a dyno tune this friday! it feels like a 75 shot of nos!! i really doubt you'll blow the heads off a motor with 8.5 to 1 compression but the cool thing about the south florida pulley system is you can get different size pullies! so if you don't want too much boost no problem just pick a bigger pulley:) i went with the lightning size but thats just me. good luck:)
Leon

Doug McGinn 07-31-2002 01:29 AM

what tool did you use to remove the old pulley and then install the new one?
How much total boost are you getting from the pulley you bought?

46stang 07-31-2002 09:21 AM

i had a puller at my work. it is similar to the one on south florida pulleys website. they sell the tool as well!! it's actually a pretty easy swap. my stock guage gets buried past the 10lb mark. i need to get an aftermarket guage for it! most of the guys i've talked to are getting 12-12.5lbs total boost. If your worried just get one of the bigger pullies for the street and then when you go to the track you could put a smaller one on! the cool thing is that pullies are easily swapable with there system!check out this site:

svtperformance.com

lots of good info on our cars there:) my buddy has a 03 cobra and i took him for a ride in mine! he is ordering some pullies for his this week!! he was very impressed:) good luck.
Leon


All times are GMT -5. The time now is 07:25 AM.