Home-made Subframe Connectors
 

I have heard of people making subframe connectors. They keep down on flex right? I would like to know how they do this and what all i need to do it with. I would like some indepth directions if available. Thanks alot

------------------
347 Stroker Motor: Balanced, A9P Computer, Cobra Transmission, Extrude Ported and Polished Upper and ported Lower, GT40 Milled Ported and Polished Heads, B303 Cam, BBK 1 5/8 Headers, 30lb Bosch Injectors, Holley Fuel Regulator, March Underdrive Pulleys, Perma-Cool Fan, 3-Core Radiator, Accel Performance Coil, Accel 300+ Racing Wires, Ram Air, K&N Filter, 79mm Mass Air Unit, FlowMaster Exhaust w/BBK Offroad H-Pipe, Hurst Short Throw Shifter, 3:55 Gears, Ram Clutch, Cross Drilled Rotors

Someone has to know this one!!

check your e-mail

i've seen it w/ about 2 1/2" square stock
You just cut the the top off for about 6" on both ends where you weld to the subframes.


------------------
4.10's,long tubes & 75 shot...Goes 12.50's
Check it out at http://www.burnouts.webprovider.com

11's coming soon!!!!
Heads,intake and cam are all here

mail it to me too

shaft7@swbell.net

------------------
SHaFTed

91GT, Flows, dumps, 70MM BBK TB, K&N, Hurst short throw, T5, 17" Lexani Roma wheels, 235/40/R17 on front, 255/45/R17 on back, mach1 hood, LX tail lights, bright red!