MustangWorks.com : Ford Forums

MustangWorks.com : Ford Forums (http://forums.mustangworks.com/index.php)
-   Windsor Power (http://forums.mustangworks.com/forumdisplay.php?f=8)
-   -   Question 4 Anyone Running Welds? (http://forums.mustangworks.com/showthread.php?t=2858)

IMPULSERACING 05-02-2001 10:11 AM

Question 4 Anyone Running Welds?
 
I'm switching to 5 lug Pro-Stars w/ 3 1/2 front and 15 x 8 1/2 back with 15 x 5 1/2 back spacing. Do I need to run spacers in the front or back?

------------------
92' LX Hatch 5 spd, Performer Intake, 1/2" spacer, pro-m 75mm MAF, 70mm T.B., 24lb injectors, 190lph, BBK fenderwall cold air, mallary ignition & coil, 1.7 rockers, Ripper Shifter, Scattershield, Dual Friction Clutch, SVO Quadrant, Long-Tubes, Off-road H-Pipe, Pro-Dumps, Auburn Pro, 373:1, Strange Axels c-clip elims, control arms, supersubs, 50/50's, Eibach frnt drag springs, Moroso rear trick springs, no sway bar, battery in hatch, 5-Lug Pro-Stars 3 1/2", 8 1/2 26x10.5" MT ET streets, N20

9

USMC302 05-04-2001 03:38 PM

Don't know muc about backspacing but am running the same rims on my 88 coupe with no spacers and they are fine. Hope this helps.

------------------
88LX NOTCH, 88GT, 95 GT.

smokedchevy 05-05-2001 12:48 AM

You won't need any spacers just get the backspacing correct. I have 15x4 and 15x8 centerline convo pros on my 92 and I fit a 28x10.5 MT tire with no problems. I had to roll the fender to get ample clearance, it's a daily driver. It even cleared the quad shocks.


All times are GMT -5. The time now is 08:37 AM.