MustangWorks.com : Ford Forums - Piston/Valve clearance

MustangWorks.com : Ford Forums (http://forums.mustangworks.com/index.php)

- Windsor Power (http://forums.mustangworks.com/forumdisplay.php?f=8)

- - Piston/Valve clearance (http://forums.mustangworks.com/showthread.php?t=30029)

chickendreamer

10-12-2002 09:36 PM

Piston/Valve clearance

Just a quick question here. E-303 cam, ford motorsport replacment lifters(FMS-M6500R302), ford motorsport replacment pushrods(FMS-M-6565-L302), 9.4 compression pistons(TRW-L2482F30), and 2.02 intake valves. If I run 1.7 ratio roller rockers will i have to worry about piston/valve clearance? All parts are shown in the www.summitracing.com catalogue.

Any input would be appreciated

bigblockcoupe

10-13-2002 08:55 AM

you should have enough clearance but it is still good to always check. it is the only way to be sure. i'm running gt-40 alum heads with a custom ground cam w/ .525/.536 lift and a stock shortblock w/ no clearance issues.

chickendreamer

10-13-2002 10:45 AM

Thanks for the reply bigblockcoupe. I'm ordering the parts from summit racing so I was trying to avoid the wrong part and have to send it back to them paying all the shipping fee's. :o

All times are GMT -5. The time now is 10:33 AM.