door hinges (pins)
 

I need to replace the hinges on my 89 GT. Only the ones on the drivers side, but I can't figure out what the best way to do it is. I'm guessing that I have to drill out the exsisting pins, or grind off the tops and knock them out. Any ideas?

------------------
89 Mustang GT

93 Bronco
4" lift, 33's
Coming soon:
2" more
35's

Grinding off the tops and knocking them out is how I did it. If you can get a Dremmel tool in their with a cut-off wheel, that should work great.

------------------
351W 89 Mustang GT Convertible

That's how I am going to do mine. I am going to do it tomorrow (Grind off the tops).

use a dremmel all the way, but get the thicker cut off wheels, you will go through a bunch but it works, i tried a sawzall with metal blades but those were chewed up way to fast, so try the dremmel with a cut off or grinding wheel and then punch the pins out from either end, be sure to support the door with a floor jack using a rag of course so you dont scratch anything, well goodluck!

------------------
1989 mustang GT mildly modified,flowmaster exhaust,pro dumps,hotchkins upper and lower control arms, ebiach springs,koni shocks,pro5.0shifter,chrome moly weld in subframe connectors,new interior now a 2 seater,8pt chrome moly roll bar and HAL K-member,coilovers,castercambers,Auburn Pro Locker,3:73's Strange Splines 31 tooth c-clip eliminators.
Mass Mustang Club

Use a fiberglass reinforced cut-off wheel.