Roush intake
 

They made one for 94-95 five liters, does anyone know where I can get one cheaper? No one ever talks about them.

------------------
95GT B303 cam, 1.7 rockers, 65mm TB, 73mm MAF, milled heads, 355's K&N, BBK Longtubes, Flowmaster cat back, pulleys, msd coil, 9mm wires, Tremec 3550, Pro5.0 shifter,10.5 Motorsport clutch, FMS aluminum driveshaft, weld in subframe connectors

The only place I've seen them is on Roush's website. I don't think the price is too bad, I'd give a left testical for one.

------------------
95 GT convertable, 3.73 gears, bbk off road h-pipe, march underdrive pullies, Saleen wires, custom made cold air induction,
Cobra intake w/ 65mm tb
GT40 heads, flowtech headers

I think it Looks great, and no one else has it. Good power numbers from what I recall. I thought the price was $2000! Much more than I would consider spending. Even for $1000, I still think not enough power for the cost.

Doesn't that intake require more than just bolt on?

I think you may need a new hood also.

------------------
1995 GT Black- Edelbrock 6037's,Intake,Edelbrock cam,70mm TB,75mm pro-m,Taylor wires, pulleys,Equal length headers,K&N filter
Flowmaster,3.73's, Eibach pro rate springs
lower control arms Centerforce clutch
New motor in the works!

What are you talking about, they're only like $600.

------------------
95 GT convertable, 3.73 gears, bbk off road h-pipe, march underdrive pullies, Saleen wires, custom made cold air induction,
Cobra intake w/ 65mm tb
GT40 heads, flowtech headers

$600? Not for the intake I'm thinking of, unless they came way down in price.

Does anyone have a picture?



------------------
1995 GT Black- Edelbrock 6037's,Intake,Edelbrock cam,70mm TB,75mm pro-m,Taylor wires, pulleys,Equal length headers,K&N filter
Flowmaster,3.73's, Eibach pro rate springs
lower control arms Centerforce clutch
New motor in the works!