cams and rocker arms???
 

i got a E cam TFS heads and a blocked that has been decked down... dunno how far down it has been deced.. bu8t can i run 1.70 rockers or even 1.72 rockers... they care comming with the heads and my stck (one of them) rockers are bent... what size rods should i need?????
HELP!!!!!!!!!!!

You're going to have to check piston to valve clearance with some clay. After all, you spent a lot of money to not check the clearances. As for pushrods, you only need new ones if you're running guide plates or the rocker arm geometry is not correct. The roller on the end of the rocker arm should contact only the center of the valve. If it doesn't, you'll need to get proper length pushrods. Even if the geometry is correct, I'd get a set of new ones, that way everything will be new and fresh.

i gonna get new ones any way since on of the old one is bent at like a 30degree angel...........