Valvetrain question for Edelbrock 6037's
 

I'm in the process of putting my 6037's on my 91GT and I am using the Crane Compucam with the .498 lift (Just like the E-cam) will I need longer pushrods to accomodate the pedestal type rockers,given the higher lift of the cam????? Or can I get away with just the rocker shims?

your pushrods should be fine. just follow the instructions given and use the shims properly (if they are even needed) and you should be good to go!
i re-used the stock pushrods with my set-up below.
Q

------------------
Quin, 87 GT,306,forged/cut pistons,edelbrock head\intak,steeda#18cam,1.7rr,MSD Blaster tfi coil,A9L,pro-m75mm,24#inj,accufab65mm,2.5"pipes,hooker headers,dynomax exhaust,3.73 gr,110 lph fp,180*therm,moroso cold air,ASP pullies, weld rims

See my engine on user rides.

I see your shwartz is as big as mine, now lets see how well you handle it!