MustangWorks.com : Ford Forums

MustangWorks.com : Ford Forums (http://forums.mustangworks.com/index.php)
-   Windsor Power (http://forums.mustangworks.com/forumdisplay.php?f=8)
-   -   How easy is it to change the speedometer cable? (http://forums.mustangworks.com/showthread.php?t=32930)

Fox Hound 01-07-2003 04:59 PM

How easy is it to change the speedometer cable?
 
My cable just melted on my exhaust and probably will have to be replace. How easy is it to change it out? I can see the tranny side but how do I get to the speedometer? Do I need to get into the dash? Any tips or tricks are greatly appreciated. TIA...

saltzstang 01-07-2003 06:02 PM

its been about 6 years....but if I remember right....you have to pull the cluster hat..then the cluster and the cable has some kind of lock fitting but I cant recall what it looked like. Thats all I can remember bud, but it could'nt be that bad because thats when I was 17 and my first mustang. Good luck!

Fox Hound 01-08-2003 11:58 AM

Anyone has detail instructions on how to remove the insturment cluster? Where are all the screws located and which ones do I remove?

drtbiker 01-08-2003 01:00 PM

mine did the same it melted on the exhaust... i still have the same cable in there and it has been working for about 7months with no problems. If your spedo still works i would hold off but that is just my 02

later

Fox Hound 01-08-2003 03:19 PM

Mine broke so I'll have to replace it. BTW, just I replaced my h-pipe and now one of the hangers is interfering with the connector of the speedo cable sort of bending it at an wierd angel. Has this happen to anyone else?

LayanRubr 01-08-2003 08:02 PM

My speedo went kapoot. All I can tell yah is that the instrument cluster isnt too hard to take off, just go to town with a screwdriver, and dont yank anything too hard :)


All times are GMT -5. The time now is 01:05 AM.