HELP Install Exployer Upper
 

Hello, I'm putting my Exployer Upper on. The EGR spacer (mustang oe) is to large it is open on the bottom. It looks like I can not use the spacer. What do I need to do with the electric connection for the EGR valve? What else do I need to do? For the coolant lines I was just going to loop them together.
Some help would be great.
Thanks

Anyone??

I have gotten rid of the egr spacer but I'm stumped on how to connect my throttle cable. Any ideas would be great.

Info
 

Check this for expert help.

www.ronmorrisperformance.com

You must have a later model Explorer without
an internal EGR passage. The above link can
help with that - he offers an EGR eliminator.

One thing - remember that without the exhaust
normally introduced into the intake by the EGR,
you're taking in more air, leaning out the mixture
a little - makes it slightly more prone to detonation.
Although, the stock EEC-IV does provide a slightly
richer mixture than a sharp tuneup will, so you
might be OK.

Thanks for your reply. I made a plate to block off the bottom of the EGR. This will work and I can keep my Emissions Legal :D