Looking for combo suggestions...
 

Looking for best known combos! I need the ultimate stroker package that is a availble. Just imagine... if you had $6000 in your hand, what motor would you drop into YOUR Stang??!! I want the strongest wheel pullin', head jerkin', tire smokin', MONSTER I can drop into my 94 GT.
Here's my current setup:
324.5RWHP+334RWFTLBS
* Anderson STAGE 2 ported Edelbrock Performer intake (~285CFM)
* Anderson STAGE 2 TFS Heads (283CFM INT/179CFM EXT)
* Pullys
* MSD 6AL + MSD coil
* 75mm BBK Throttle Body
* 80mm Grenatelli MAF
* MAC Cold-Air induction
* 24lb injectors
* Anderson B2 cam
* Anderson PMS computer (tuned by Anderson)
* 1.6 full roller rockers
* MAC H-Pipe
* No cats w/Hooker mufflers
* Tremec 3550
* Alum. Driveshaft
* 3.73 gears w/stock axles
* In-tank 255GPH BBK fuel pump

Probably a few other things I can't recall right now... but the ONE thing you DON'T SEE above is a modified botttom end. Unfortunately, its a bone-stock bottom end! This is where I need everyone's assistance...

Any suggested web pages I could check out, suggested engine builders, or any other advise is welcome! PLEASE HELP! I need to get this damn car into the 11's!

Thanks again guys and gals!

------------------
ONLY 325 RWHP??? DAMN...

How much money do you have to spend...=) hehe...R302-billet crank-billet rods.ahh wish I had that! Where are you located, I know a few great engine builders in the Illinois region, email me if your in this area. Rurockn@aol.com Otherwise the new Sportsman 302 block looks like a nice setup for the new year! Run one with 4340 internals and pull some power in the top end without any worries!