temp
 

what temp does you guys' car run at mine seems hot... i have a MR. gasket 180* high flow and a new radiator and it still runs at 200 - 210 it even ran that way before the swap...

thanks

What kinda guage u got?

------------------
-1989 Saleen Mustang #406- TFS Heads, E-303, edelbrock intake,70MM TB, 73mm MAF, off road H, headers and 3chamber flows.
12.55@107mph
50-175 Nitrous Works WET Kit just added.

I was posting problems like this a while back. Make sure the ground wire from your wire harness to the engine is grounded correctly (On a fox it's and orange cable on the back of the block), also check the ground cable from the engine to the chassis. The service manual tells you how to use two resistors (Radio Shack) to check proper operation of the guage. I ended up having a bad temp sender.

i have autometer gagues. this is my second gage and my second unit... and it still runs hot like around 200-210...

------------------
ALL NEW PPG Torch Red 95GT, 304ci block, Forged pistons, Ported Explorer Intake, E-303 cam, fully ported and polished and milled E-7 heads, 75mm MAS, BBK Adj. fuel Reg & gauge, BBK Shorty Headers, BBK H-pipe, March Pulleys, 2 Chamber Flowmasters, Kenny Brown 6 point Roll cage, Kenny Brown Panhard Bar, Powerslot Rotors, PBR twin piston calipers, Eibach Sportline Springs, 180* Thermostat, 1/2 Plenum Spacer, MSD 6AL, MSD Master Blaster, MSD 8.8 Wires, 24# Racing Injectors, AFS 10.5" Cobra R's, Nit