Cam specs
 

Cam motion said this is what I need.
Duration @ .050 216, lift 531, 114 lobe sep, install @ 112

What do yall think?

Low duration and high lift will probly make alot of torque and be good till around 5500 or so.

I just finished looking in MM&FF in the head test section. The cam used there is very close to the one that cam motion is cutting for me.

got that article right here. ;) seem like with a good set of heads and intake it is making great power. almost 400 with the afr 165's.

Can you run that much lift with 2.02 valves and stock pistons?

I did a clerance check last night.With the E-cam, 100 thou on the exhast, 70 thou on the intake. I can bolt them up and let her rip. Then when the other one comes in I will put it in in a few weeks.

Did you use clay to check your piston to vlave clearance?

Yes clay, and play dough. It came out the same either way.