"PLEASE" Help my Chevy driving brother.!!
 

My dad and brother just installed a set of sportsman 2 heads on my brothers 81' Camaro. He has the following motor and mods.

406 small block, performer RPM intake, Holley 750 carb, comp 491 lift cam, 1.6 roller rockers, Headers, Holley fuel pump,
World products sportsman 2 heads, Turbo 400
with 3rd degree shift kit, 2500 stall, 3.73
gears.

After they installed the heads, the motor rumbled louder than ever and had real quick throttle response, so they couldnt wait to get it out in the street. They stalled it up
gunned it and tore the pavement off the road
but then hen the car got over 3000 RPM's the cars power was gone. When he would shift through the gears the car wouldnt pull for
sh!t. I dont think that the problem is in the motor I think that something is wrong with his stall converter. The car ran 14.30's before the heads and now it would be lucky to run a 15 the power is not getting to the wheels.

------------------
88 mustang gt convertible bored to 306 BBk equal length headers mac cold air fender kit cowl hood nitto drag radials ford racing clutch flow masters h-pipe 160* thermostat 16 degrees of timing electric fan off 94' t-bird jacobs electronics cap and wires. Edelbrock 1 1/2 inch drop springs.
best 60 ft 2.14, best 1/8th 9.65, best 1/4 15.2 @89mph, Stock gears and 3000+ Altitude

I don't think that that big of a problem would come from just the stall. Might be the intake isn't flowing enough, or lack of fuel.

I think it could be caused by either a lack of fuel or to much fuel being poured out.

------------------
347 Stroker Motor: Balanced, Cobra Transmission, Extrude Ported and Polished Upper and ported Lower, GT40 Milled Ported and Polished Heads, B303 Cam, BBK 1 5/8 Headers, 30lb Bosch Injectors, Holley AFPR, March Underdrive Pulleys, Perma-Cool Fan, 3-Core Radiator, Accel Performance Coil, Accel 300+ Racing Wires, Ram Air, K&N Filter, 73mm Vortech MAF, 70mm TB, FlowMaster Exhaust w/BBK Offroad H-Pipe, Hurst Shifter, 3:55 Gears, Ram Clutch, Cross Drilled Rotors, AC and Smog del, rear seat del.

He needs a fuel pressure gauge so that he knows for sure what the pressure is when the power disappears. Does it smoke at all when this happens? What do the plugs look like? Is it a mech. secondary or vac.? Help me help you.

Take care
~Chris

------------------
Retired Moderator
MustangNet
My site: JimPorterRacing
RACECAR spelled backwards is RACECAR

HEY !!! Are you ASE Certified ??? If you are, ask me about iATN. The best tool you'll ever have, and it's free !!!