how much power????
 

I have a 93 lx with the following mods, powerdyne 9lb kit,24 lbs injectors, 77 pro-m, 75 t-body, 190lph fuel pump, mac headers,bbk x-pipe, flowmaster catback, underdrive pulleys, electric fan, and some type of cam, not sure what it is?? i think its a e cam. Thanks

Well lets look into the magical crystal ball.... I'm guessing at around 290-330hp.

Just take it to the track and see what it run in the 1/4 or 1/8. Those numbers are the only ones that matter anyways.;)

I am gonna guess 275 at the tires (if its a stick).

Also how do you have underdrive pullies and a blower?

The last time i ran it, it ran mid 13's but that was with only 5-6psi b/c of a boost leak and the clutch was sliping a little. This summer i plan to get heads,intake,blower cam, rockers,etc.

You should put about 300 to the ground IMO.

I have a similar set up as yours except I have slightly worked stock heads (does not matter much, they are garbage anyway) and an Edelbrock performer intake. I make about 11 psi with my BD11-A.
My engine is also 10 to 1.
I pulled a particular LS1 car that I know by about 3 cars from a roll in just 3rd gear. He runs high 12's at 108-109.

You can make a bit over 300 at the wheels with your set-up, but it really depends on the tune. Blower cars can be real dogs if they are not tuned right.

Absolutely correct. It's amazing the difference adding a couple of degrees of timing and subtracting a few % fuel can make. I'd say with a decent tune 300+ is very possible.

I WOULD SAY UR PUTTING 275-290 TO THE FLYWHEEL.
PUT A SMALLER PULLY ON BLOWER...... IF YOUR BOTTOM END IS IN FAIR CONDITION, U SHOULD BE ABLE TO RUN 12-14 PSI.

What was the Trap speed?